Production Engineering - Medical Equipment Division

PEMED HOME 6035 E. 38th Avenue, Denver, Colorado 80207 USA (303) 393-7800 FAX (303) 393-1482

Wheelchairs / Homecare

Click here for:

Pumps, including compression and feeding

Air float system - $275 each

List: $670. MedCon: G. Lapidus air float mattress system, made by Hamilton American. Prevents pressure points from building for bed-ridden patients.

Features:

one/two pads selector switch
on/off switch
carrying handle

Shipping weight is about 30 pound. 8 units in stock.

Patient mobile stand - $975

List: $8,400. MedCon: G. Needs new battery, has some rips in upholstery. Mobile stand "stand-up" wheel chair. Uses twelve volt sealed automotive type battery to propel a wheelchair patient in stand up position. Will raise patient up from prone position on floor. Features:

push button battery voltage meter
forward/ reverse powder switch
steering handle
high/low speed switch
dual seat-belt type straps hold patient into unit
chest rest

Unit will raise patient from prone position on floor to a full standing position, and lower them back again when they are done with their activities. In this way, patient is on same eye level as walking patients. Unit needs a 12 volt battery charger, shipping weight is about 275 pounds.

Universal pole clamp - $30 each

List: $55 each. MedCon: N. 3 way IV pole/ surgical attachment clamp. Adapts for either IV pole or flat surface mountings. "Quicktrans" clamp, cat # 8C100A, made for IVAC by Pryor products. Black anodized aluminum, machined from 1 solid block.

About 130 units in stock.

Hoyer lift - $650

List: $1,600. MedCon: VG. Patient lift. Invacare Invalex lift model 9901. All stainless hydraulic patient lift for removing patient from bath tubs and into wheelchairs, adjustable spear angle base, 4 casters on base, with 2' sling support. Missing fabric sling.

Production Engineering - Medical Equipment Division

6035 E. 38th Avenue, Denver, Colorado 80207 USA (303) 393-7800 FAX (303) 393-1482

© Copyright 1993- 2008 by Production Engineering. PEMED® is a registered trademark of Production Engineering. MedCon is also a trademark of Production Engineering. All rights reserved. Contact PEMED for license requests. The usual copyright notices and disclaimers. Except for search engines or link listing, no part of this website, including derived information, may be republished without express written permission and payment of fees.